Shutter Star

WHAT IS IT?
The Shutter Star is a quick, simple and strong alternative to traditional shuttering methods.

Product Demo

Below is the product demo for the Shutter Star, which demonstrates how the product can be used in a step-by-step guide. Use the '<<' and '>>' buttons to step through the demo.

About The Product

When a gap is formed between the beams, just cut the timber to length and drill one hole in the middle at 500mm intervals. Slide a cable tie through the hole and through the Shutter Star. Then attach another cable tie onto it in order to lock. Repeat the process until all the board is complete.

Slide the board between the beams so it hangs just under the joint - the Shutter Star will sit in between the beams on the bottom of the soffits. Once in position, pull the cable tight to tighten the board - simply, if you can pull a cable tie then you can fit this system.

It's a lot easier than trying to twist wire tight or prop timber underneath the beams, as all the work is done from on top of the slab and, as a result, is not hindered by fall protection. The joint can be filled flat and neat with no hindrance from bars and no after work required, apart from removing the shutter board itself.

There is less material wastage, no rust leakage and less chance of the board dropping, which gives a neater job in a lot less time.